Fluvial morphology and sediment-flux steering of axial-transverse boundaries in an experimental basin

Sean D. Connell, Wonsuck Kim, Chris Paola, Gary A. Smith

Research output: Contribution to journalArticle

8 Citations (Scopus)

Abstract

The distinction between depositional belts associated with the basin axis and flanking piedmont streams is a fundamental attribute of the stratigraphic architecture of intracontinental rift basins. Spatiotemporal distributions of these lithofacies associations are sensitive to a combination of factors, including basin geometry, subsidence rate, and sediment discharge; however, most studies have focused on one or two controls and one depositional component (axial or tributary) of the basin-fill succession. A new perspective on how these depositional belts develop under simple but precisely controlled boundary conditions of steady subsidence, sediment flux, and water discharge is achieved through the creation of an experimental stratigraphic succession. The Experimental EarthScape run in 2006 (XES06) focused on the geomorphic evolution of sedimentary successions within an asymmetrically subsiding basin, analogous to a simple half graben, containing four interacting supply points of sediment and water. Under the imposed conditions, the experimental system self-organized into an axial stream flanked by transverse fans. Imposition of various combinations of longitudinal and lateral sediment flux showed that the locations and widths of the axial and transverse systems were strongly controlled by relative sediment fluxes ("flux steering"), and less influenced by the location of the subsidence maximum and subsidence rate. The axial drainage was dominated by transversely sourced sediment through toe cutting of the transverse fans, except during the highest axial-sediment discharges. Footwall fans persisted even under conditions of very large axial-sediment discharge, aided by topographic inheritance of the steeper transverse depositional slopes.

Original languageEnglish
Pages (from-to)310-325
Number of pages16
JournalJournal of Sedimentary Research
Volume82
Issue number5
DOIs
Publication statusPublished - 2012 May 1

Fingerprint

basin
sediment
subsidence
basin fill
footwall
piedmont
lithofacies
graben
tributary
boundary condition
drainage
geometry
water
rate

All Science Journal Classification (ASJC) codes

  • Geology

Cite this

@article{9762bc66dd814b8fb71a5033e711fb2a,
title = "Fluvial morphology and sediment-flux steering of axial-transverse boundaries in an experimental basin",
abstract = "The distinction between depositional belts associated with the basin axis and flanking piedmont streams is a fundamental attribute of the stratigraphic architecture of intracontinental rift basins. Spatiotemporal distributions of these lithofacies associations are sensitive to a combination of factors, including basin geometry, subsidence rate, and sediment discharge; however, most studies have focused on one or two controls and one depositional component (axial or tributary) of the basin-fill succession. A new perspective on how these depositional belts develop under simple but precisely controlled boundary conditions of steady subsidence, sediment flux, and water discharge is achieved through the creation of an experimental stratigraphic succession. The Experimental EarthScape run in 2006 (XES06) focused on the geomorphic evolution of sedimentary successions within an asymmetrically subsiding basin, analogous to a simple half graben, containing four interacting supply points of sediment and water. Under the imposed conditions, the experimental system self-organized into an axial stream flanked by transverse fans. Imposition of various combinations of longitudinal and lateral sediment flux showed that the locations and widths of the axial and transverse systems were strongly controlled by relative sediment fluxes ({"}flux steering{"}), and less influenced by the location of the subsidence maximum and subsidence rate. The axial drainage was dominated by transversely sourced sediment through toe cutting of the transverse fans, except during the highest axial-sediment discharges. Footwall fans persisted even under conditions of very large axial-sediment discharge, aided by topographic inheritance of the steeper transverse depositional slopes.",
author = "Connell, {Sean D.} and Wonsuck Kim and Chris Paola and Smith, {Gary A.}",
year = "2012",
month = "5",
day = "1",
doi = "10.2110/jsr.2012.27",
language = "English",
volume = "82",
pages = "310--325",
journal = "Journal of Sedimentary Research",
issn = "1527-1404",
publisher = "SEPM Society for Sedimentary Geology",
number = "5",

}

Fluvial morphology and sediment-flux steering of axial-transverse boundaries in an experimental basin. / Connell, Sean D.; Kim, Wonsuck; Paola, Chris; Smith, Gary A.

In: Journal of Sedimentary Research, Vol. 82, No. 5, 01.05.2012, p. 310-325.

Research output: Contribution to journalArticle

TY - JOUR

T1 - Fluvial morphology and sediment-flux steering of axial-transverse boundaries in an experimental basin

AU - Connell, Sean D.

AU - Kim, Wonsuck

AU - Paola, Chris

AU - Smith, Gary A.

PY - 2012/5/1

Y1 - 2012/5/1

N2 - The distinction between depositional belts associated with the basin axis and flanking piedmont streams is a fundamental attribute of the stratigraphic architecture of intracontinental rift basins. Spatiotemporal distributions of these lithofacies associations are sensitive to a combination of factors, including basin geometry, subsidence rate, and sediment discharge; however, most studies have focused on one or two controls and one depositional component (axial or tributary) of the basin-fill succession. A new perspective on how these depositional belts develop under simple but precisely controlled boundary conditions of steady subsidence, sediment flux, and water discharge is achieved through the creation of an experimental stratigraphic succession. The Experimental EarthScape run in 2006 (XES06) focused on the geomorphic evolution of sedimentary successions within an asymmetrically subsiding basin, analogous to a simple half graben, containing four interacting supply points of sediment and water. Under the imposed conditions, the experimental system self-organized into an axial stream flanked by transverse fans. Imposition of various combinations of longitudinal and lateral sediment flux showed that the locations and widths of the axial and transverse systems were strongly controlled by relative sediment fluxes ("flux steering"), and less influenced by the location of the subsidence maximum and subsidence rate. The axial drainage was dominated by transversely sourced sediment through toe cutting of the transverse fans, except during the highest axial-sediment discharges. Footwall fans persisted even under conditions of very large axial-sediment discharge, aided by topographic inheritance of the steeper transverse depositional slopes.

AB - The distinction between depositional belts associated with the basin axis and flanking piedmont streams is a fundamental attribute of the stratigraphic architecture of intracontinental rift basins. Spatiotemporal distributions of these lithofacies associations are sensitive to a combination of factors, including basin geometry, subsidence rate, and sediment discharge; however, most studies have focused on one or two controls and one depositional component (axial or tributary) of the basin-fill succession. A new perspective on how these depositional belts develop under simple but precisely controlled boundary conditions of steady subsidence, sediment flux, and water discharge is achieved through the creation of an experimental stratigraphic succession. The Experimental EarthScape run in 2006 (XES06) focused on the geomorphic evolution of sedimentary successions within an asymmetrically subsiding basin, analogous to a simple half graben, containing four interacting supply points of sediment and water. Under the imposed conditions, the experimental system self-organized into an axial stream flanked by transverse fans. Imposition of various combinations of longitudinal and lateral sediment flux showed that the locations and widths of the axial and transverse systems were strongly controlled by relative sediment fluxes ("flux steering"), and less influenced by the location of the subsidence maximum and subsidence rate. The axial drainage was dominated by transversely sourced sediment through toe cutting of the transverse fans, except during the highest axial-sediment discharges. Footwall fans persisted even under conditions of very large axial-sediment discharge, aided by topographic inheritance of the steeper transverse depositional slopes.

UR - http://www.scopus.com/inward/record.url?scp=84864344678&partnerID=8YFLogxK

UR - http://www.scopus.com/inward/citedby.url?scp=84864344678&partnerID=8YFLogxK

U2 - 10.2110/jsr.2012.27

DO - 10.2110/jsr.2012.27

M3 - Article

AN - SCOPUS:84864344678

VL - 82

SP - 310

EP - 325

JO - Journal of Sedimentary Research

JF - Journal of Sedimentary Research

SN - 1527-1404

IS - 5

ER -